News classification
Contact us
- Add: Fuyong in shenzhen city, guangdong province town of white stone mansion west industrial zone of A4
- Tel: 86-0755-27380299 27386566
- Fax: 86-0755-27396623
- Email: 136-0041-0733曾生
Spring manufacturer to improve the performance of heat treatment method
Shenzhen hon JieWuJin spring factory to improve the performance of heat treatment
Heat treatment furnace manufacturers are adopting the design of the new features to improve their overall temperature distribution of equipment: along with the improvement of environmental flow pattern, careful design of energy and power density has brought very good useful working ability.
Consistency is the process of aviation and automobile customers, the main problem, compatible with higher acceptable standards are heat treatment equipment manufacturers and build confidence between customers. When the design of the control system of heat treatment furnace design and process of expert match, this is especially true. These knowledge and special design products and systems to help ensure that maintain was accused of parameters in the acceptable range.
Modern control system design is mainly consider three questions:
(1) most modern heat treatment furnace with low heat physical isolation of gain and thermal hysteresis is becoming the load size and the main factors of set point, instead of heat treatment furnace structure or its components.
(2) the special consideration of the actual workload temperature, customers are looking for their control algorithm, so more heat treatment temperature optimization method using specific workload.
(3) acceptable to the general heat treatment through specific classification definition heat treatment furnace for approval. In order to obtain the maximum efficiency and volume of the production planning ability high, heat treatment equipment have been working in the most appropriate level is the key.
Customer recurring problems are excessive workload temperature drift, it happens at startup or trajectory slope, even in charged area and requirements of thermal trajectory is very close. Because many of the artifacts have different cross-sectional area, hate the temperature drift of lead to destructive consequences, especially in the thin section of load parts. These drift can cause heat treatment furnace fault audit. Because of this, many users to use excessive elimination and gain quite poor optimization method, it has been added to the heat treatment cycle time.
Consistency is the process of aviation and automobile customers, the main problem, compatible with higher acceptable standards are heat treatment equipment manufacturers and build confidence between customers. When the design of the control system of heat treatment furnace design and process of expert match, this is especially true. These knowledge and special design products and systems to help ensure that maintain was accused of parameters in the acceptable range.
Modern control system design is mainly consider three questions:
(1) most modern heat treatment furnace with low heat physical isolation of gain and thermal hysteresis is becoming the load size and the main factors of set point, instead of heat treatment furnace structure or its components.
(2) the special consideration of the actual workload temperature, customers are looking for their control algorithm, so more heat treatment temperature optimization method using specific workload.
(3) acceptable to the general heat treatment through specific classification definition heat treatment furnace for approval. In order to obtain the maximum efficiency and volume of the production planning ability high, heat treatment equipment have been working in the most appropriate level is the key.
Customer recurring problems are excessive workload temperature drift, it happens at startup or trajectory slope, even in charged area and requirements of thermal trajectory is very close. Because many of the artifacts have different cross-sectional area, hate the temperature drift of lead to destructive consequences, especially in the thin section of load parts. These drift can cause heat treatment furnace fault audit. Because of this, many users to use excessive elimination and gain quite poor optimization method, it has been added to the heat treatment cycle time.
