Shenzhen hon JieWuJin spring factory specializing in the production of precision springs, metal stamping, metal lathe, CNC lathe processing hardware, automatic lathe processing, hardware electronic cigarette, atomizer, spring electrode and other precision hardware manufacturers. White stone mansion is located in shenzhen fuyong town west industrial zone of A4.

The repetitive production of automatic lathes: the proportion of working hours with nc grinding machine is high. Process analysis preparation, such as programming, parts first adjusted trial cut, etc., the sum of the comprehensive working hours tend to be individual parts processing hours on dozens of times to one hundred times, but these CNC lathe work content can be stored repeatedly used, so a part on the nc grinding machine successfully trial-produced repeat and put into operation, greatly reduce the production cycle, less cost, can achieve better economic benefit.

It is required that the key parts of processing quality can be effectively produced in the medium and small batches: CNC grinding machine can realize high precision, high quality and high efficiency grinding process under computer control. It can save a lot of special equipment and equipment, have strong flexible manufacturing ability and obtain better economic benefits than special grinding machine. Compared with ordinary grinding machines, it can eliminate many man-made interference factors in the long process flow of complicated processing, the precision of machining parts is consistent and the interchangeability is good, the processing efficiency is high.

Automatic lathe processing parts should meet can give full play to the technological characteristics of centralized processing with CNC CNC grinding machine grinding machine for grinding wheel cutting the workpiece when machining parts with corresponding numerical control grinding machine is exactly the same, but it can make some composite processing, with processing precision requirements, such as the scope of grinding ways, ordinary grinding machine is mainly used for grinding cylinder, circular cone or CNC lathe ladder shaft shoulder end face grinding ordinary lathe, CNC cylindrical grinder in addition, can also grinding ring surface, and the combination of various forms of complex surface.

Parts processing economic batch batch should be greater than the ordinary lathe numerical control car, the small batch parts in the nc grinding machine processing, due to various reasons, cutting time of only 10%, 30% of the actual working hours. This category in the center of the grinding process more focused on nc grinding machine processing, the proportion could rise to 70% ~ 70%, but ready to adjust working hours tend to be longer, so the parts will become not economic batch is too small.

Numerical control lathe machining of some special parts considered although there are some parts processing bulk is small, but ordinary lathe complex shape, high quality, requires good interchangeability, this can not meet the above requirements on the CNC grinding machine, can only arrange to machining on CNC grinding machine, such as a parabola, cycloid CAM and special type surface mirror mirror etc.