Shenzhen hon JieWuJin spring factory introduces several common methods of spring deburring.

Core tip:

A:

1. According to different workpiece, the deburring methods also change accordingly.

2. Whether the enterprise's actual situation, in combination with the products of the company, to determine the deburring solution.

3. According to the size of the workpiece burr to determine the solution.

4. According to the different methods of processing plan is determined.

2:

1 hole: use the chamfer and the diameter of a knife or the front end of the bit

2: use file, abrasive, sandpaper, grindstone,... With containing abrasive nylon brush cheap line

3 welding slag: vibration welding slag tools also can remove the crisp burr

Outer diameter: 4 with lathe guide Angle when processing

5 and polishing, grinding, sandblasting, depends on what artifacts and product requirements

Three:

According to the product to decide the deburring process, if it is a single product manual to the good.

1: electricity chemical deburring. If the homemade equipment, the cost is not high, the economy, efficiency and use.

2: vibration grinding deburring gear (burr), high efficiency and quality can also.

3: heat treatment parts can also be through shot peening deburring, can also eliminate surface stress

4: use air pressure gun with various shapes of spear deburring effect is good, efficiency is also high

Gear deburring can use the following methods:

1: electrochemical deburring, highest efficiency, best quality, but the equipment cost is too high, general of small businesses can't afford to use;

2: vibration deburring, general quality, but the cost is low,

3: the manual deburring, quality is better, just may lower efficiency;